No Print Profile yet. Add one to earn points.
This is version 2 of the design backporting all the learnings from the release of EMS 300/350.
The frustration of using VHB tape mounted to a printed piece emulating a DIN rail with yet another printed mount for each of the electronics boards to be installed in the Voron V0.2 got me thinking of an echo-system to address this need.
The design consist of a hex cut out board mounted directly to the rear extrusions with 4 screws. The electronic/cable duct mounts come into play after the board is installed. To do this, you will need to download and print the mounts along with a pair of bolt-ons for the boards you intend to use. There is also a cable management module created to help manage wiring (especially the long stepper motor wires). There are 2 versions of the cable management lid depending if you intend to use the expansion board or not.
Do let me know which boards you intend to use and I will be publishing a library of mounts that will work across the EMS ecosystem.
This model will need to be printed on a bed capable of printing 226mm x 124mm. The parts are recommended to be printed in ABS or ASA since the V0.2 is an enclosed printer and the chamber will get hot. All parts are oriented correctly to just slice and print. No supports are required.
Additional parts necessary are as follows: -
EMS is designed to be extremely flexible as to let the user decide what hardware to use on the printer. Therefore we have created a mounts repository where power supply, controller board, expansion board and single board computers (Raspberry Pi) mounts are stored. Please visit our mounts repository to download universal cable ducts and mounts for the hardware you intend to install - https://www.printables.com/model/558357-ft-ems-mounts-repository
I built my printer using the FromBot kit and had to make several adjustments. Take note of things to look out for: -
If you like my designs and would like to contribute to fund filaments and other equipment required for prototyping, please do so at my paypal.me or Ko-fi. Your support is greatly appreciated :)