The BB-MP9 is a prop gun for cosplay or display purposes. Heavily inspired by the Brugger & Thomet MP9 submachine gun, but with some obvious differences. This was just a quick model I made for fun, while working on a more difficult project so I will most likely not be updating it any further.
Recommended Filament Type: PLA+ or PETG
Required Hardware:
8 x M3*6 bolt
2 x M3*10 bolt
1 x M3*12 bolt
4 x M3*15 bolt
2 x Pen Springs (1 for the trigger and the other for the magazine release)
1 x Compression Spring: OD: 10mm, WD: 0.8mm, Length: 50mm