Cherry Blossom Coaster Set
Copyright Claim
Cherry Blossom Coaster Set
Boost
28
37
1
Print Profile(1)
0.16mm layer, 2 walls, 15% infill
Designer
8.2 h
3 plates
Boost
28
37
1
0
41
21
Released
Description
I made some cherry blossom coasters with a holder to store them!
This is a set of 4 coasters and the holder that all sit flush together. I made indentations on the bottom of the coasters to fit rubber feet.
I set a mug on a coaster with boiling water for ~20 minutes and small warping occurred so I wouldn't recommend using hot drinks for long periods of time.
If you like what I'm doing, consider buying me a coffee. Much thanks!
Comment & Rating (1)
All
Print Profile
0.16mm layer, 2 walls, 15% infill
Soooooo pretty. A bit of clean up needed and the stamens are delicate.. These are large coasters, I am probably going to try printing smaller so that I can put 4 to a plate.
0
Reply
No more
License
This work is licensed under a
Creative Commons Attribution-NoncommercialRelated Models
© 2024 MakerWorld