Picatinny MP7 Grip by Qwerm

A picatinny version of the folding grip from the MP7A1. This is designed with some tight tolerances so it will most likely require some post processing to get things to move smoothly. I recommend using a file and then running the moving parts back and forth until they move smoothly.

Print Orientation: Check included pictures for recommended print orientations.

Recommended Print Settings:

Layer Height: 0.2mm

Wall Line Count: 4

Infill Density: 30%+

Support: Yes

Fuzzy Skin: No

Required Hardware:

1x M5 30mm Socket Head Screw

1x M5 Hex Nut

1x 6mm E-Clip

1x 1/8" x 1" Roll Pin

1x 1 1/2" x 1/4" Compression Spring