small desk lamp
created in fusion 360

photos show printed in matte black pla, brick red petg-cf, and transparent petg

• 0.16mm layer height
• 15% adaptive cubic infill
• supports needed on the base (manually painted)

this is a small desk lamp, with a polygon desined shade and a transparent PETG insert (optional) if you want to have a more diffused light

you need to have simple E14 lamp socket with a threaded ring holder and a power cable with light switch, and you just need to:

1. attach the lamp socket to the base using the threaded ring
2. pass the cable through the hole on the back of the base
3. connect the cable wires to the lamp socket
4. add the lamp
5. screw the shade into the base
    

the shade is threaded so that you can then screw it into position after you've added the lamp - make sure you go for a thinner model of lamp so that there is no clearance or heat issues

there is also an insert that slides into place from the top opening in case you want a more diffuse light, however this is optional, I personally prefer without it

3mf includes three plates one with the base (textured PEI), one for the shade (engineering plate), and one with the insert(engineering plate), feel free to adjust to your plate preference also depending on the material you choose

in my opinion this model pairs very well with my stackable storage box, and desk organiser as you can see on the photo

If you enjoy using this 3D model and are able to, please consider supporting my work by buying me a coffee. Your contribution goes a long way in fueling future creations. Thank you for being a supporter!

note: all photos uploaded are of the actual printed model, taken inside a lightbox or in natural light on top of a desk / table