Panda Touch Stand
Copyright Claim
Panda Touch Stand
Boost
14
32
10
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
1.2 h
1 plate
Boost
14
32
10
0
104
97
Released
Description
Simple stand for the Big Tree Tech Panda Touch. It uses all for mounting points on the frame and is secured using the screws provided with the Panda Touch.
Comment & Rating (10)
All
Print Profile
0.2mm layer, 2 walls, 15% infill
Great design, thanks very much
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
nice print job with petg cf
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Well designed model, and it printed perfectly. I used a dual extrusion black and white filament with five walls to try and make it as hefty as possible. My initial concern was that it would be so lightweight I can never pull the screen away from the base without lifting up everything as well because the magnets are so strong. In hindsight That's not realistic. Meaning you're just going to have to use both hands if you want to pull the screen away from the base plate.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Printed amazingly in Bambu Lab PLA and works perfect!
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
perfect
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Overall well done.... but the balance was not perfect. It can fall forward with the screen attached.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Printed several of these and didn’t have an issue.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld