All my friends went out and bought fancy coffee machines. I'm a Nerd, I like coffee but not enough to spend a ton of money on one. So I decided to design and print up one. Will need good heat-resistant filament that is safe to use for food. 
 

How to use:

• Place the shorter part on top of the coffee cup (holes can let you see inside)
• Make a wide hole in the top of the Nespresso pod, and a small hole in the bottom of the pod. 
• place the pod in the shorter unit, it only goes in one way
• place the second longer unit on top in its place
• pour in your warm water into the top that you will see is a funnel 
• it will drain down through the coffee cup

Note:

• This is version 1 
• it needs work
• there will be coffee grounds in the cup (Again its version 1)