These are ‘Pin Art’ inspired square-shaped fidget toys. I designed one size with two different styles: Plain and Plaid.

I found these printed great on my A1 with all the ‘small’ squares sticking nicely during print and moving freely within the print afterwards. Just in case you print it and the ‘small’ squares are getting stuck/fused - I also designed a second file for each style that has more tolerance (+.1mm tolerance).

So in my print profile you will find:

Plate #1: Plain Square of Squares (1 color)

Plate #2: Plaid Square of Squares (3 colors)

Plate #3: Plain Square of Squares (painted with stripes, 2 colors)

Plate #4: Plain Square of Squares (+.1mm tolerance, 1 color)

Plate #5: Plaid Square of Squares (+.1mm tolerance, 3 colors)

Plate #6: Plain Square of Squares (+.1mm tolerance; stripes, 2 colors)

3D PRINTING SETTINGS

Layer Height 0.2mm

PLA works great

15-20% Infill

No supports

Dimensions: 2 ⅜ in x 2 ⅜ in.

Print tips:

• I recommend using a smooth print plate
• You can pre-treat the print bed with a glue stick or hair spray if needed
• Note: in my print profile under the ‘Strength’ tab then the ‘Walls’ tab I turned on ‘Detect Thin Walls’ (I found for the Plaid Square of Squares +.1mm tolerance file it wasn’t printing all the ‘plaid’ lines when this setting was off)

These are loads of fun to play with and I think can be printed in a lot of fun color combinations:)

Have fun printing!