Angle Finder by Josh-3D

Josh-3D

Tools>Measure Tools

Print Profile(2)

All

P1S

P1P

X1 Carbon

X1E

A1 mini

0.2mm layer, 3 walls, 10% infill

Designer

1.1 h

1 plate

5.0(14)

A1 Mini Friendly 0.2mm layer, 3 walls, 10% infill

1.2 h

1 plate

Boost

132

Released

Description

I needed a simple angle finder, and didn't find one on here, so made this one! Each tick on the face represents 10 degrees

I recommend printing it out of PLA Tough/Plus/Pro, PETG, or ABS/ASA, as I'm not sure if basic or matte pla will hold up for the hinge part, when you snap it together.

The fit is meant to be a little tight/stiff, so when you set it, it stays.

Comment & Rating (19)

@user_599930234

I printed this out of PLA+ and while it printed fine, the tick marks basically melded together and are not legible. maybe deeper/wider grooves for the markings would be better for single color prints?

(Edited)

The designer has replied

@Josheh_3D

Ah! Thanks for the feedback. I'll look into doing a version tailored for single color printing. That doesn't help at the moment, but, feedback heard!

@jurgenadevries

Printed great with Bambu Labs Basic matte PLA on a P1s

@NCDesigns

Print Profile

0.2mm layer, 3 walls, 10% infill

Fitment was perfect!

(Edited)

@fran.guri12

Print Profile

0.2mm layer, 3 walls, 10% infill

@pipsprints

Print Profile

0.2mm layer, 3 walls, 10% infill

@andr00ahayes196

Matte PLA works just fine, I used Overture white matte PLA for the markings and Red Polyterra for the part, Some numerical markers at each 45-degree mark would be nice.

The designer has replied

@Josheh_3D

Thanks for the feedback on this! I'm not sure if I can fit numerical markers on there, but I have been thinking I can at least adjust the length to help make it easier to identify how far one has gone.