Hey y'all. The original shade for the ceiling fan in my bedroom suffered an accident and needed to be replaced. So I designed this one to do the job.

Its roughly 250mm round by 120mm tall. Should work with ceiling fans with a 10.5mm center hole in the same style. This particular ceiling fan is the Harbor Breeze Lake Canton.

Prints with the solid side down as featured in pictures. No supports are required. I recomend using the liquid adhesive with this one to prevent curling as it takes up the whole build plate.

General Settings:

0.4mm Nozzel

0.2mm First Layer

0.14mm Following Layers

20% Gyroid Infill

4/6 Solid Bottom\Top Layers

3 Walls

I hope someone else out there with a similar fan enjoys this one. Please like and Follow. All the support helps.