Glock stand with magazine holder
Copyright Claim
Glock stand with magazine holder
Boost
149
229
30
Print Profile(3)
Version 2_higher mag holder
Designer
2 h
1 plate
Version 4
Designer
3.5 h
1 plate
Version 1
Designer
2 h
1 plate
Boost
149
229
30
3
323
157
Released
Description
Stand for glock gun with two magazine holders. Fits all glocks with the same dimensions as gen5 G19/17.
Comment & Rating (30)
All
Print Profile
Version 2_higher mag holder
très joli support très bien ajusté.
(Edited)
1
Reply
Print Profile
Version 4
pla打印沒有問題。
0
Reply
Prints without any issues and fits perfectly
0
Reply
great model, any chance u could design one for a beretta m9
The designer has replied
0
Reply
i dont have beratta to measure it and make model
0
Reply
Replying to @Dejf
if it wouldn’t be too much trouble I could take some measurements if you lmk which measurements you need. I just have no clue what I’m doing in 3d modeling software💀
0
Reply
Replying to @scottyscott
its a bit complicated... i need to know dimension of the triger guard, distance and size of the mag release button, slide stop, disassembly lever and shape of a gun around the trigger. And then I need to know the approximate center of gravity to set the right angle of holder.
But ther will be solution B: I work on some kind of universal holder for most of handguns... so it could be used for you.
0
Reply
Print Profile
Version 2_higher mag holder
0
Reply
Print Profile
Version 1
Interesting concept. Does NOT fit .45acp Double Stack Glock Mags despite description. Also, walls on mag wells and trigger guard cover are very thin and flexible.
(Edited)The designer has replied
0
Reply
ouch, my fault... sorry. i will edit the description. thanks for info. i thought that all double stack has the same width.
0
Reply
Replying to @Dejf
No worries, still a cool concept! It's a bit narrow and short for the 45 double stack. Still, holds my 30S nicely next to my computer, I just laid the spare mag on the base plate.
0
Reply
Print Profile
Version 2_higher mag holder
vertical mag holder is very fragile, had several failures trying to remove from bed. finally had to use CA glue to put it bavk in place because i was over wasting filament
Strength Issue
The designer has replied
0
Reply
Try the "Version 4" print profile... there is new stronger construction of the model and its made of PETG which provides you stronger and a bit flexible outcome then the PLA version
0
Reply
Print Profile
Version 2_higher mag holder
good model and the only one i have found that supports a loaded magazine, the only complaint is where the pistol rests is very flimsy and thin and snapped, attempting again in PETG-CF
1
Reply
Print Profile
Version 4
fits a printed g19 nicely
0
Reply
Print Profile
Version 2_higher mag holder
amazing print
0
Reply
License
This work is licensed under a Standard Digital File License.
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Related Models
© 2024 MakerWorld