Print the latest Version 2 for the best look!!!

Remixed this for my P365 with adding three mags to it. Thanks to Veracon for providing the silhouette of the Lifepod 2.0.

Version 1 is without the SIG logo and fits stock 10 round mags the best. Print this unit face down for best finish, this also allows for the use of build plates with unique finishes like diamond or carbon fiber.

The design was done to be tight for the pistol to allow for little movement.

The complete extrusion allows for the use of the thin stock foam between the lid/printed holder for better protection and to further limit movement. Also use the thin foam underneath the insert.

4-15-24 Uploaded a V2 with chamfered/Filet edges all around. Added a 45 edge at the magazine holders to allow for finger extensions on the mags and added the SIG logo.

4-19-24 The unit has been test printed and it prints best face up with tree supports, supports can be tricky to remove and the back finish is rough but that is not seen. This also allows for a stock 10 round mag to be seated and fits the pistol in the cutout together, thus allowing for possibly 4 mags to be stored in the lifepod. The complete extrusion allows for the use of the thin stock foam between the lid/printed holder for better protection and to further limit movement. Also use the thin foam underneath the insert.