Last year my apple tree attrached some ground bees. This year I got a new A1 mini, figured I would try out my new printer, and make a really easy fake wasp nest. The print turned out ok - near the top there was a clog/defect in the print, and near the end didn't look the best, but I am going to use it.
This print is in a vase mode, with 4 bottom walls. The bottom holes are ½" diameter 1" on center. I just put a zip tie in them and hung it outside. It's mainly in the shade, but for only $0.50, I can print another one if the sun ruins it.
Size: 151mm DIAM X 178mm HEIGHT
Quick Print:
Vase mode
4 base walls
Time: 1 hour 42 mins
Filament: 43g Silver PLA+
Let me know if you want anything else!