I have designed my first HueForge model, which is inspired by the “THIS IS FINE” meme. Instead of sitting in a burning room, this dog is sitting in the sinking titanic, enjoying his coffee/tee. I have used 7 colors for this print with 2 AMS units.

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

The Model is 176.78x170mm in size
You may print at higher layer heights below the Min Depth of 0.24mm
The Max Depth is 2mm and the Actual Depth is 1.9mm

Filaments Used:
PLA BambuLab Basic Black Transmission Distance: 0.6
PLA BambuLab Basic Blue Transmission Distance: 4
PLA BambuLab Matte Dark Brown Transmission Distance: 2
PLA BambuLab Basic Gray Transmission Distance: 2
PLA BambuLab Basic Orange Transmission Distance: 5
PLA BambuLab Basic Yellow Transmission Distance: 6
PLA BambuLab Basic Jade White Transmission Distance: 5
This print uses 7 unique filaments

Swap Instructions:
Start with Black
At layer #6 (0.56mm) swap to Blue
At layer #8 (0.72mm) swap to Dark Brown
At layer #12 (1.04mm) swap to Gray
At layer #13 (1.12mm) swap to Orange
At layer #14 (1.2mm) swap to Yellow
At layer #19 (1.6mm) swap to Jade White for the rest.

I hope you will have fun with it!