Backbone V2 Case
Copyright Claim
Backbone V2 Case
Boost
1
3
1
Print Profile(1)
0.2mm layer, 6 walls, 15% infill
Designer
10 h
2 plates
Boost
1
3
1
0
2
1
Released
Description
This is a hard case that holds the backbone V2, phone adapters, and a USB cable. The case lid slides and locks into place. I printed in ABS and PLA with no issues.
Comment & Rating (1)
All
Print Profile
0.2mm layer, 6 walls, 15% infill
Finally I managed to close the lid but it's really difficult to open and especially close it, and the box is really huge. There is opportunity to save a lot of time and filament by reducing the thickness of the model. The box is heavier than the backbone.
(Edited)0
Reply
No more
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld