I was cleaning up my workspace and realised I had too many nozzles (don't tell my missus). I had found some models online but struggled with them, my fingers were too big to get into them and screw in (or out) the nozzle from the container.

I found the Latching Box model and thought it would work well to create my own and store my Nozzle collection. Once I determined the size, I was able to add sufficient threaded holes to hold all my nozzles, and the fact that the top is mostly open and free, I can easily remove or screw in the nozzles from the box.

This is print-in-place, and the only support is on the latch on the lower section, I did not use a brim. I used PETG, only because I had some leftover, and it matched my hotend storage boxes, but PLA or any other filament should also be fine.