A set of funny commemorative coins to print as a joke or a game with your friends. Comes in two sizes, a small 40mm for .2 nozzle and a bigger 45.2mm for .4 nozzle. Each coin prints in 3 pieces: a front piece, a back piece, and a connector piece. Everything snaps together - no glue required. I recommend using a dark blue, bright red, and silk gold or regular gold filaments for best color results.
Coin 1 says “I WAS RIGHT YOU WERE WRONG” with a trophy on the front and a medal on the back.
Coin 2 says “I SURVIVED 20 APRIL 2024 COMMEMORATIVE COIN” on the front with a leaf on the back.
Coin 3 says “ONE MINUTE SOBER ONE DRINK AT A TIME” with a 1 on the front and a beer mug on the back.
Here are the .2 nozzle profile minimums:
Profile: .10mm standard preset
Ironing type: Top surfaces, Rectilinear
Wall generator: Arachne
Wall loops: 4
Sparse infill pattern: Gyroid
Brim type: Outer brim only
Brim-object gap: 0.15
Here are the .4 nozzle profile minimums:
Profile: .12mm Fine preset
Layer height: 0.1
Initial layer height: 0.1
Line width
Default: 0.22
Initial layer: 0.25
All others: 0.22
Elephant foot compensation: 0.15
Ironing type: Top surfaces, Rectilinear
Wall generator: Arachne
Wall loops: 4
Sparse infill pattern: Gyroid
Brim type: Outer brim only
Brim-object gap: 0.15
The single coin print profiles include a Make My Sign template for you to edit and customize however you like with your own inside jokes. Note: currently, there is a bug where every time you click on a template link it warps words so you'll have to move them back into place but hopefully it will be fixed soon.
Also, upon downloading the coins from Makerlab, make sure to use the following Z settings (Make My Sign currently cannot have more than 2 layers):
Red circle: change Z to .1
Text and shapes over blue: change Z to .4
Text, shapes, SVGs, and stickers over red circle: change Z to .8
Secondary shapes over red circle: change Z to 1.4
Check the preview and make sure you have 4 yellow base layers, 4 blue layers, 4 red layers, and 4 more yellow layers. Since there's no snap to center on MakeMySign I would also recommend centering the Backdrop+Border, then blue circle, then red circle, then all the rest together to make sure it's all perfectly layered.