新版V2.0 请移步到  也可以关注来及时获取新的设计  https://makerworld.com/zh/models/435936#profileId-341027

For the new version V2.0, please move to  https://makerworld.com/zh/models/435936#profileId-341027

全部模型不需要支撑

用时大约44分钟。耗材消耗不足15克

需要在需要安装的位置开一个直径22mm的孔

打印为PC4-M6气动接头，内置优化版M6螺纹，可轻松手拧。

气动接头固定在一体打印的球阀结构上

不会受到耗材的方向限制

使用耗材丝来固定铰链

工作原理 打印两个逐渐狭窄的薄片用来卡住耗材，防止脱落

使用8mm圆形磁铁（不高于2.5mm）从这个方向塞入，注意磁极的方向

The pneumatic joint is fixed to the integrally printed ball valve structure.

Will not be restricted by the direction of consumables.

no need support

It takes about 55 minutes. Consume less than 15g

Open a hole with a diameter of 22mm where it needs to be installed

Printed as pneumatic PC-M6 connector, with built-in better M6 thread, which can be easily hand-tightened.

Use filament wire to secure hinges.

Working principle: Print two gradually narrower sheets to clamp the filament and prevent it from falling off.

Use an 8mm round magnet (no higher than 2.5mm) and insert it from this direction, paying attention to the direction of the magnetic poles.