This retro game console keychain set printed and tested with Bambu Lab P1P. No glue needed. All parts locked nicely but it's depends by printer. If its not locked very well try to change hole settings in your slicer.

Filaments and Colors

All parts printed with Esun PLA+ filaments.

• Esun PLA+ White
• Esun PLA+ Pine Green
• Esun PLA+ Very Peri
• Esun PLA+ Yellow
• Esun PLA+ Red
• Esun PLA+ Silver
• Esun PLA+ Grey

Remcomented Print Settings

The printouts you see in the picture were printed with these settings. All settings just for better printouts. Not required. All parts printed with 0.20 layer height.

Device 

device-bottom.stl (textured plate)

• No any special setting needed. Maybe you can print it on a textured plate for realistic bottom view. ıf you have.

device-button.stl (smooth plate)

• Ironing Type: Top surfaces
• Ironing Pattern: Concentric

device-top.stl (smooth plate)

• Ironing Type: Top surfaces
• Ironing Pattern: Rectilinear

Controller

controller-arrows-buttons.stl (smooth plate)

• Ironing Type: Top surfaces
• Ironing Pattern: Concentric

controller-circle-button.stl (smooth plate)

• Ironing Type: Top surfaces
• Ironing Pattern: Concentric

controller-circle-button-wrapper.stl (smooth plate)

• Ironing Type: Top surfaces
• Ironing Pattern: Concentric

controller-inside.stl (smooth plate)

• No any special setting needed. Don't forget to turn this piece upside down on a smooth plate.

controller-start-and-option-buttons.stl  (smooth plate)

• Ironing Type: Top surfaces
• Ironing Pattern: Concentric

Logo

logo.stl  (smooth plate)

• You can paint red after the 20th layer.
• Ironing Type: Top surfaces
• Ironing Pattern: Rectilinear

Don't forget to share your makes. Thank you!

Happy printing. <3