Car air freshener compatible with Maison Berger

I designed this housing for the Maison Berger air fresheners because the original made too much noise in the car. The one I purchased was from the adjustable series so as to decide how much air to pass inside the perfumer and therefore intensify the perfume or not. The only flaw was the noise because, having no constraints, the internal ring vibrated endlessly.

I found a compromise, I made sure that it can still be adjusted but with some limitations while avoiding the annoying scraping noise.

The model is made up of 4 pieces that I personally printed in ABS with a closed chamber because for this type of object it seems to me to be the best alternative in terms of quality/price ratio. You will need:
- 16 neodymium magnets measuring 5x2mm
- Quick-setting glue
- Drooler
- Patience

Front and Back are the two pieces where the perfume will stay where you will need 4 magnets and which will block the perfume. For the Back you will also need 6 other magnets which will connect to the Bottom. The bottom is the part that thanks to Clip will be positioned on the air vent of your car. Clip can be mounted in 4 directions (rotating it 90°). Please pay attention to the orientation of the magnets between the pieces. I advise you first of all to orient them all in the same way for one of the two faces that will then join and then, being careful about the orientation, insert the others.

The magnet hole is right for the magnets I indicated so that they fit together perfectly if the glue doesn't have its effect, so I recommend deburring the housing slightly so that their positioning will be easier.

If you have any other questions don't hesitate to contact me or comment :)

You can find the air fresheners replacement at this link:
https://www.maison-berger.it/diffusori-automobile/