ADD A 100MM EXHAUST PIPE

This is a bracket to attach to the back of your printer and fits to existing screw holes (see diagram image) for adding a hot swappable 100mm exhaust pipe for ventilation.

Items used:

• https://www.amazon.com.au/OKUMEYR-Ventilation-Insulated-Flexible-Pipeline/dp/B0CK75KNV6
• https://www.amazon.com.au/DUCTURBO-Ventilation-Transfer-Boosting-Controller/dp/B09WKMYPYY
• https://www.amazon.com.au/Countersunk-Machine-Fastener-Assortment-Storage/dp/B08FT7VZT4
• https://www.amazon.com.au/Yakamoz-Machine-Thread-Titanium-Tapping/dp/B0BXN9Q7HB

Instructions:

Use a standard M3 thread tap to thread the three unused holes on the panel (no drilling required).

You can use about a 10mm long screw no issues. The holes on the model line up perfectly and have a small tolerance to account for material shrinkage. The second printed part you need to tape to the insulated flexible pipe as shown in the photos and there is a slot which is locks onto with a small turn and allows you to hot swap your hose with other devices.

Printed and tested on a bambulabs P1S.