DJI OSMO Pocket 3 Hard Case with custom insert.

***I have added an insert that accommodates 2 x MIC 2's and micro SD cards***

You can print this case and change up the insert down the track as I have created a nice tolerance to keep the insert fixed, but still be able to pull it out.

You will need 6 x M3 30mm screws/bolts. 4 x 3-4mm flat top small screws to fasten the lid organiser (but thats not required as its a snug fit).

The seal should be printed in TPU.

Use your choice of foam to stick or push into the lid with a wide brim screw head.

There is an optional lid organiser net that should be printed in TPU to get your fingers behind it to store some other cables etc.

I have a hard lid organiser also for velcro to secure a small velcro pouch which you can find on aliexpress or amazon easily.

There is a slot for an AirTag to be placed in the backend on the insert also :)

All plates are labelled with what there are. Print each part separately as I have in the 3MF for the best results using a slow setting.

Open to ideas if there are other insert configurations, please checkout my instagram for more custom case designs.