A detailed Airbus A350 model. It is likely the most detailed A350 model for 3D printing online. No AMS needed. Glue needed. Super glue works fine if printed in PLA. It resembles the real A350 as much as possible aerodynamic-wise, while some modifications for easy 3D printing and better visual effects are adopted. The assembly instruction is located at the end of the page. To make the curved winglets, soak the tips of the wings in hot water to soften them and bend them upward very gently. The wing tips are very fragile.

2 print profiles are available. They have been tested on A1 Mini and P1S, and they both take about 10 hours:

1. Small Version with 0.2 Nozzle: Length: 17.5 cm (~7 in) Space and filament savings.
2. Large Version with 0.4 Nozzle: Length: 35 cm (~14 in, because of A"350") Just purely awesome if space and filament are not problems.

Disclaimer: Airbus and China Eastern Airlines did not sponsor this project. If you own these companies, please consider hiring me.

超级精细的空客A350模型。可能是全网最细节爆炸的可3D打印A350客机模型。不用AMS，但需要速干胶，PLA的话502就行。我尽量把它的空气动力学模仿出来。稍微改了一些地方，主要是为了便于打印和最终成品效果。组装说明见下面。如果想做出翼尖小翼翘起来的样子，把主翼浸入热水中，然后轻轻折一下，小心别弄断了。

目前有两个打印配置。都在A1 Mini和P1S上测试过，都耗时大约10小时：

1. 小款，用于0.2打印头：长度：17.5 cm 省地方省耗材。
2. 大款，用于0.4打印头：长度：35 cm（因为A“350”嘛） 帅就完事了，打这个如果时间和耗材不是问题。

声明：空客和东方航空没给这个项目任何帮助。但如果您是它们的老板，求考虑聘用我。

Assembly Video (EN)

组装视频（CN）

Stand 底座

Engine 引擎（Repeat for the Right Side，右侧同理）

Wing 机翼（Repeat for the Right Side，右侧同理）

Cockpit and Fuselage 驾驶舱和机舱 (Don't forget to assemble the APU at the tail. APU exhaust up. 别忘在机尾装APU。APU排气孔向上)

Apply Livery (China Eastern Livery is available in PDF. It is the simplest livery I could find.)

上涂装（我上传了东航的涂装。选它因为简单。）

If printed on regular A4/Letter paper, please use white (school) glue to apply the decals.

如果用普通的A4纸打印，建议使用白胶固定。

Done！完工！