TL;DR: A Poop Bucket that is big in volume, yet slim in width; shallow in depth, yet sufficiently tall, requires a poop deflector, perfect for those with A1+ Top Mount AMS Lite.

LUX Poop Deflector available here:
https://makerworld.com/en/models/463352

I was browsing through the available poop buckets on Makerworld and I didn't quite like them because of the extended wall height that was meant to deflect the poop into the bucket. I saw the one that has a handle and I felt it was quite excessive. I saw small poop buckets that moves with the 3D printer but I was worried about bigger multicolor prints. I just want a bucket that is big enough so that I am not worried about clearing it, and at the same time visibility was important to me. Then I saw some poop deflectors that allows you to have shallower buckets without those extended walls. The buckets that were designed to be paired with them look awfully plain to the extent that I can just place a generic container beside it. I felt that I want something designed or customised. I liked how some buckets are shaped to match the side of the A1. So what I did was to take what I like about the different designs, extend it forward as much as possible without blocking the vents near the front and extending it out backwards as much as possible until it hits 250mm. The poop bucket only adds 50mm to the side of the A1.