Adjustable phone holder for tripod quick release atanasovgoran
NOTE: I am not satisfied with the design
This is and adjustable tripod phone holder for a tripod, with the an optional power bank holder.Haven't printed this yet, so the tolerances are not tested.For springs or for springs and power bankRequirements:
4x M3 screws with bolds
4x springs that fits the above screws
1x M8 screw with bold
1x spring that fits the above screw
(+1 Rubber band optional to hold the power bank)Instructions:
- Print either "for-springs" or "for-springs&power-bank".
- Use the M3 screws and bolds and the springs for the holders that hold the phone from the back and the front.
- Use the M8 screw and bold and the spring for the holder that holds the phone from side to side.
- Glue the base to the rest.
For rubber of for rubber and power bankRequirements:
6 Rubber bands
(+1 Rubber band optional to hold the power bank)Instructions:
- Print either "for-rubber" or "for-rubber&power-bank".
- Print 1x the "column-for-rubber" in the original size
- Print 2x the "column-for-rubber" a little bigger than the size of the phone
- Use the rubber bands between holders of the phone.
- Glue the base to the rest.
Price | Free |
Category | DIY |
Downloads | 4571 |
Views | 2740 |
Likes | 1 |
Uploaded | 03/24/2016 |
This work is licensed under a Creative Commons Attribution 4.0 International License.
column-for-rubber.stl
(3 KB) |
View 3D Render Download |
for-rubber.stl
(157 KB) |
View 3D Render Download |
for-rubberpower-bank.stl
(196 KB) |
View 3D Render Download |
for-springs.stl
(421 KB) |
View 3D Render Download |
for-springspower-bank.stl
(459 KB) |
View 3D Render Download |
Note: if you want to re-download a file, please do so from your Purchases page or the product page. Download links are set to expire. You might get an error if you try to re-download a file from your browser's downloads page.
No comments yet!
Please login or register to write a comment.