DJI Inspire 1 Battery Discharging-Props

SummaryThe goal is to produce as much air resistence as posible and zero lifting force so the batteries can discharge at ground at full motor power without creating turbulences. DJI recommends to fully discharge the Batteries of the DJI Inspire 1 every 20 charting cycles. For quick release 1345s version. In my several tests, discharging times from 100% to 15% were about 20 minutes at 75% throttle. Although the props have a safety ring on the top, DON'T TOUCH them when they are spinning. VERY IMPORTANT: Use high quality and durable Filament (PETG recommended) Print slow ( < 40 mm/s ) Infill > 30, ideally 100% Use perfect finished Props only. If a unit is not perfect, throw it away and print a new one. As the integrity of your Aircraft depends entirely on the build quality of the printed Props, I can't be responsible of any damage the Props could cause on your Aircraft.Print SettingsPrinter Brand: UltimakerPrinter: Ultimaker 2Rafts: NoSupports: NoResolution: 0.1mmInfill: >30Notes: VERY IMPORTANT: - Use high quality and durable Filament (PETG recommended) - Print slow ( < 40 mm/s ) - Infill > 30, ideally 100% - Just use perfect finished Props. If a unit is not perfect, through it away and print a new one. Post-PrintingRunning at full-speed