Nidoran♂ Male,Nidorino,Nidoking Evolution - FAN ART - POKÉMON FIGURINE -POKEMON

This is "Nidoran♂ Male,Nidorino,Nidoking Evolution" from Pokemon series
I will be releasing my work on daily basis, some may even be free! so please follow and keep your eye on my updates !!cheers

PLEASE CHECK THEM OUT(OTHER 3D MODELS FROM THE SAME DESIGNER)!

Nidoran♂ is a small, quadrupedal, mammalian Pokémon. It is pinkish purple with darker patches. It has large, spiny ears with teal insides, oversized front teeth, and red eyes. Its back is covered with three lines of large spines that can release potent poisons if threatened. The center line of spines is taller than the other two. The size of the long, pointed horn on its forehead is indicative of the strength of its venom. Nidoran♂ is a male-only species.

Nidorino is a light-purple, quadrupedal mammalian Pokémon. It has several darker purple patches across its body. It has large, spiny ears with teal insides, narrow black eyes, and a long snout with two pointed teeth protruding from the upper jaw. Nidorino has a ridge of toxic spines on its back and a long pointed horn on its forehead. The horn is harder than a diamond and capable of secreting poison on impact. The more adrenaline Nidorino has in its body, the more potent the poison is. Its short legs have three claws on each foot. Nidorino is a male-only species.

Nidoking is a large, bipedal, purple mammalian Pokémon with distinct reptilian features. It has narrow eyes, large, spiny ears, fur-like tufts on its cheeks, and a short snout filled with pointed teeth. There is a long, venomous horn on its forehead and a ridge of spines down its back. Gray plates cover its chest and belly, and there is a gray, rounded spine on each elbow. Each hand has three claws, while each foot has only a single hoof-like nail. It has a long, powerful tail. Nidoking is a male-only species.

*This model require minor support to print with FDM .
*to have a better print result I would suggest to print this model in angle where the front surface facing upwards to avoid support structure in FDM prints, for DLP & SLA should be fine.