Xbox One Thumbstick Extensions

A friendly reminder:

These are not to be sold for your own profit. If you sell these, I will find you.
Make them, enjoy them, and share them with your friends!

These are stick extenders for the Xbox One controller to help with precision, primarily in FPS games. I had a similar store bought product for the Xbox 360, and didnt feel like shelling out the extra money for the Xbox One version. This is my best version so far, but I may be uploading additional revisions.

Please read the instructions quick before printing, and please let me know how yours come out if you do print some!

DISCLAIMER: I AM NOT RESPONSIBLE FOR ANY JOYSTICKS THAT MAY BE DAMAGED IN FITTING THESE PARTS ON YOUR CONTROLLER.

Be gentle, and hold the head of the joystick as you push the extender down. DO NOT just mash down until the part fits. If it feels like your print came out too small, don't force it!

Print each stick extender individually

I ran these off on a Solidoodle 2 at .3mm layer height, brim and concentric fill.

Print this part upside down, and you won't need supports.

When I ran off more than one of these at a time, the part quality improved visually, but the fit of the final part was too loose.

I will be revising this design at some point so that I can print two or more out at once without losing the snug fit required.

If your pieces do come out fitting loosely, you may have some luck putting something like paper towel, or some other thin material underneath to tighten it up.