Awesome Phone Stand Tripod Compatible

Dear Makers,

Let me present to you: Tcherno's Awesome Phone Stand!

This model is an upgrade of the "Smart Stand" uploaded by muzz64 on Thingiverse.

/!\ YOU MAY HAVE TO DOWNSCALE FROM 100% TO 10% IN CURA /!\

The original design was meant to be put on a flat surface and hold a phone at different angles. You can still do the same with this model and I added some more possibilities :

- usable on flat surface AND on any tripod/monopod with a standard camera mount,
- optimized for horizontal and vertical position (horizontal for phones up to ~8.2cm wide, so almost any phone),
- safety arm for safer use in vertical position,
- usable while the phone is charging in both postions,
- angle adjustable,
- Tcherno's Signature version available :D

I hope you'll find this object useful! I'd love to see your prints! Check the printing information below, and feel free to contact me if you have any question!

I'll add many more prints soon so stay tuned! ;)

Printing recommendations:

/!\ YOU MAY HAVE TO DOWNSCALE FROM 100% TO 10% IN CURA /!\

Files:

The object is in 4 parts that I call the holder, the mount, the nut and the bolt. There's two versions of the holder, a "neutral" version and a "Tcherno's Signature" version ;) that's just a little something that I like to add to my creations and remakes :D

I uploaded the files of all the different parts separately, as well as the two versions of the full kit.

Every file is added in the recommended position to print. Ready-to-print!

Support:

Only the holder needs support.

Layer height:

I printed every part in 0.2mm layer height. I don't recommend any thicker layer for the nut, the bolt, and the mount (parts 2,3 and 4). The holder can probably be printed in thicker layers, I haven't tried though. Feel free to experiment!

Infill:

The default 20% infill is fine. However, I recommend 30% or 40% for the bolt, or whatever percentage you consider to be stronger, as my first attempt printed in 20% quickly broke.

-