AMOEBA STRIKER Lightweight Carbon Outer Barrel

Hey

This file is an Ultra light outer barrel for Amoeba Striker that fits all the striker models.

Stock weight : 238gr

Lightweight 3d printed : 68gr

Tube needed : Carbon; 28mm outer diameter, 26mm inner diameter, 500mm tubes can be easily found it on Aliexpress for cheap

Step by step build :

1) Remove your stock outer barrel and handguard, let your inner barrel and hop up inside

2) Screw the outer barrel base on the receiver, gently but not overtight.

3)Insert the carbon tube in the outer barrel base until it pushes onto the hop up unit : this ensure the hop up unit is straight, in the barrel and cylinder axis, and has no movement at all. Then, mark with tape how deep the tube should go in the barrel base and unscrew the base+tube. Then glue it together using the tape as a limit and a protection against the leaking glue on the tube. EASY!

4) Define how long your outer barrel must be (overall length should be the same as your stock barrel, under hole must be at the same spot), then cut it, straight, mark with a pen where the under hole must be located and insert+glue the threaded barrel cap that is also a barrel spacer for the end of the inner barrel.

5) Once dry, cut the inner barrel if needed, then install the handguard and ENJOY!

Wall/First layer/Top layer : 2mm

Infill : 30 or more, gyroid

material used : PLA