Footwear for makerbeams

This is simple footwear for makerbeam well euh beams

It is in openscad so u can change the parameters.

There are simple version en versions that are a bit overdesign but both work fine.

O there also a experimental corner piece it is a bit hard to print because of the overhangs

for more info on makerbeam see http://www.makerbeam.eu/ and no i am not working for them ;-)

Instructions

Wel just print and put it on on your makerbeams

If it does not fit open Foot.scad and change the value

makeSpace = 0.15 into something lager :-)

If you need more then 4 feet then change

nrOfFeetX = 2;

nrOfFeetY = 2;