1/64 Diecast Showcase (Modular)

STL files have high quality mesh structure.

The biggest beauty of this showcase is that vehicles do not go out unless you want them to. Even if it falls, the vehicles do not move because they are glued. Even if it falls, vehicles cannot get out unless the windows are broken.

A modular showcase for 1/64 scale vehicles. You can make multiple layers by adding them on top of each other. It has a solid structure. You can connect dozens of them on top of each other. You can also use them individually if you want.

I put the cover on the top. I also made a wall mount for you. You can nail this design to the wall if you want.
I glued my cars with hot glue (invisibly). Double sided tape works as well.

I made 2 different window designs. One has 5 leds and the other has 4 leds. You can print the one you like the most (you can use two different designs at the same time, they are compatible with each other). If you want, you can also produce different solutions. You don't have to use LEDs.

Size for background photos: 40x104 mm
Dimension for ceiling: 40.30x104 mm
Dimension for side long picture: 47x108 mm
Size and font size for vehicle names: 80 x 6.5 mm (12 point)
Glass size: 107.5 x 52.6 x 3 mm

I really liked this showcase, I think you will too.

I printed and tested one by one at home. I am sure you will not have any problems during installation. If you have a problem don't forget to give feedback and I will help you.

Don't forget to check out my other designs!

YouTube assembly video is here: https://youtu.be/Krn_XA_PkUo

Showcase;
Layer height: 0,2 Recommended (lower value is better quality)
Number of wall lines: 2
Supports: Yes (It requires very little support. Optimized for minimal material waste.)
Support Angle: 80
Support Z distance: 0.18 mm
Infill: %20 or higher
Fan: %100 (for pla)

Top cover (I am using this model):
Layer height: 0,2
Number of wall lines: 2
Supports: NO
Infill: %20 or higher
Fan: %100 (for pla)

Top cover with Hole:
Layer height: 0,2 Recommended (lower value is better quality)
Number of wall lines: 2
Supports: Yes (It requires very little support. Optimized for minimal material waste.)
Support Angle: 88
Support Z distance: 0.16 mm
Infill: %20 or higher
Fan: %100 (for pla)