T-35A Tank New Version 1:35

The T-35 was a Soviet multi-turreted heavy tank of the interwar period and early Second World War that saw limited production and service with the Red Army.

This model was created from scatch using Blender3D and its meant to be resin printed but some of the bigger parts can totally be FDM printed.

The model is scaled and designed to be printed in 1:35 scale, but can be scaled down to fit smaller printers

The model measurements after printed are:

1:35 or 100%: 116 mm x 282 mm x 101 mm

1:48 or 73%: 85 mm x 205 mm x 74 mm

1:72 or 48.6%: 56 mm x 137 mm x 49 mm

The model is divided into 105 parts: Hull, Turrets, Tracks and Details.

Important, you need a big printer for this model, or to scale down the pieces, which might make the smaller details too small, please let me know if theres any issues and ill edit some parts to have a simple version.

If you find any issues with the model or you would like me to add/change anyting please let me know.

Printed in PLA

5-10% infill

1.2mm layer height

50mm/s speed

Support active: 5% density 60% support interface desity

Build Plate Adhesion: Brim

For Sla Printing:

This mode has a lot of thin details, make sure you add a fair ammount of supports and angle the tracks so that theyre standing, then rotate to have the least amount of overhangs for better surface finish

make sure to hollow the model and add draining holes when needed, make sure to angle the parts in such a way that there are not flat parts, to decrease sagging on the model.