Fire Hydrant Stash Container

A stash container modeled after a standard Fire Hydrant (or at least the ones I see here in South Carolina)! This model prints in separate pieces with zero supports required with the individual pieces threading together, and the front cap acting as a lock to hold the inner container in place.

There are 2 different inner containers available:

1) A container with a "secret" compartment underneath, so there are two different storage compartments
2) A container with one large storage compartment.

**This design is uploaded with a non-commercial license. Purchasing this file does not grant you the right to sell commercially.

If you would like to consider gaining access to ALL of the models and the rights to print and sell, you can check out my Patreon at
https://www.patreon.com/thinair3D

Printing Info:
**These are just the settings I used to test the model, feel free to use whatever settings work best for you.
- FDM or Resin: FDM
- Scaling: Scaling up should be fine, clearance might get tight if scaled down too far.
- Supports: None
- Infill/Perimeters: I just used 15% infill with 2 perimeters.
- Nozzle Size: 0.4
- Layer Height: 0.2
- Material: Any

Printing Instructions:

• Choose whether you want the full storage container or the container with the secret compartment.
• Print the container you choose along with the body, front cap, top cap, and 2 side caps.
• Thread pieces together afterwards, installing the container before the front cap. The front cap acts as a lock to hold the container closed.