Longer Ray5 10W fine height adjuster remix for 1/4-20 hardware

This is a remix of the Ray5 Fine height adjuster by StorminN found in Thingibles. I remixed this due to not being able to find much hardware in 6mm, especially full thread hex head bolts in 60mm length. It is remixed to accommodate 1/4-20 hardware. The adjuster knob should be printed with a raft and should be set to have a support blocker in the center section only. The knob is designed to have the print paused at approximately the 70th layer and drop in a 1/4-20 nut (which is why the support blocker for that part only). then when the print is resumed, the nut will be incased in the knob assembly. this will make a very smooth movement between the 1/4-20 x 2 1/2" full thread hex head bolt, and the knob. the top and bottom bracket have also been remixed to accommodate the 1/4-20

Rafts:
Yes
Supports:
Yes
Resolution:
1.2
Infill:
75
Filament brand:
Any

Filament color:
Any

Filament material:
PLA

Notes:
if you mix in Cura, set the veiw to X-ray, so you can see that you placed the support blocker to be able to completely clear the hex hole in the knob of supports.. to see area for support blocker
if you turn on xray view, you will see the open hex area for the hex nut. this is where you need to add support blocker using cura.