MEW FULL CONTROL XYZ CHALLENGE PRINT-IN-PLACE

Hi! I designed this Mew with the intention of being able to print it without supports.

The file includes three mews with different length, a mew easy to print without supports, shorter. A medium sized mew about 15cm that prints without supports quite easy, although it requires more control on your printer. And a third mew about 18cm tall that after many attempts, I have not managed to print.

This is a 3d printing challenge, you can print in order of difficulty, or go straight to the most complicated challenge!

I designed this mew inspired by the pin-control challenge from https://fullcontrol.xyz/#/models/67cf20 so the design has some similarity. I wanted to check if with an organic model I could also get the same results, and the answer has been yes!

It's a bit of a challenging challenge for your printer, if you manage to print the Mew Hard Version, let me know by making a make!!!

https://youtube.com/shorts/J9tK6cHJ0qQ?feature=share

If you post the challenge on social media, use the hastag #mewfullcontrol so we can see everyone's results!

I put this paid file, because I spent a lot of filament doing tests to bring this challenge, however, you have the easiest version completely free on my Cults profile.

**Printing tips: Level the bed well, when you have it perfectly level, level it again ;), once you have the bed perfectly flat, make sure your printer belts are at the correct tension. Use the right filament temperatures, and keep in mind that the speed can affect the last sections of the print!

That's all!!! Happy printing :D

If you want to sell my prints, you can get a commercial license as long as you have an active Patreon subscription https://www.patreon.com/sheikoner

**IMPORTANT NOTE. Please note that designing these models takes time, testing and prototyping until you get the final version, and the price is low enough to support the creation. If you have any suggestions on a specific topic, please do not hesitate to contact me via social networks.

I printed at 0.2 layer height, 50mm/s the easy and medium version. The hard version, I tried many settings and was not able to print it.

If you manage to print the Hard version, use the hastag #mewfullcontrol or tag me on social media!