This staff is based on White Mage Staff by WarderiiK on Sketchfab https://sketchfab.com/3d-models/magic-of-the-heavens-white-mage-staff-5daecb0ec7dc452d8d0b85dfdf0b1b76.

** Update 10.9.2023: New arc and handle-top to make stronger joint between the two. **

Most parts are printed horizontally in two halves to keep them strong. The star is kept in place by two 0.2 mm steel wires (fishing line works also well) going trough the the star and the holes in the arc. When painting the arc, insert thin wires in the holes to keep them open. Paint the halves of he star separately. Strain the wires though the holes in the arc. Finally glue the halves of the star together over the wires.

The ring for the attachment of the pearls is a heated metal wire pushed in the handle. You can use any pearls, but I have also attached a file for the pearls. I printed the pearls using 0.12 mm layer, 0.36 mm line width, and reduced (92%) flow rate.

The wings are made of white PETG and the rest of grey PLA. Supports are needed only for the wings.

Updated the wings, since they were easily broken at sharp corners. Also repositioned them for maximum strength.

I used 3 walls and 2 infill walls, which makes a total of 5 walls. Maybe I overdid it.