F18 Hornet Flying Glider Powered by an Elastic Band
F18 Hornet Flying Glider Powered by an Elastic Band
Published 2015-09-14T17:18:08+00:00
Inspired by the amazing Super Stratos Glider comes a colection of 3D printable plane models of real aircraft that actually fly!
Here's the F18 Hornet, used by the US Air Force. The US's first strike aircraft this plane is extremely durable. Hornets suffering direct hits from surface-to-air missiles have not only survived but been repaired and back flying the very next day! This model is true to the F18's form apart from a slight change to the wing profile and shortening of the nose to ensure longer glide times and more stable flight however if hit by a missile I don't think you'll get it flying the next day! Quick, cheap and easy to print (support free), these planes provide hours of fun and all you need is an elastic band!
If you have a heated/glass print bed then it can save you a lot of time and effort if you print the glider without a raft. Your print layers need to be set to either 0.2mm or 0.1mm (the wings are 0.4mm thick and the wing detail an extra 0.2mm). Your initial print layer cannot exceed 0.2mm. Ideally align your first print layer running parallel to the cockpit and then vary your print layers by 90 degrees (not 45 degrees) to prevent warping of the wing. It's not the end of the world if you don't do this but it is recommended. The dihedral wing joint (the two grooves running down the cockpit) must be clamped and glued to the central shaft in order to pull the wings up into a shallow, symmetrical 'V' - highly important for stable flight. Assemble using a good model glue. I've found the best technique for launching is: Attach an elastic band, you can use trial and error to find your preferred length and strength, to the 'trigger'. Hold the plane horizontal by the tail, put your first and second fingers on the top side and your thumb on the bottom. Pull back and increase the tension in the elastic band making sure it isn't twisted. Aim the plane at a slight upward angle and fire! From experience, if flying your plane in a field with long grass make sure you keep an eye on where it lands!
Date published | 14/09/2015 |
Time to do | 150 - 165 minutes |
Dimensions | 143mm X 150mm X 13mm |
Technology | FDM |
Complexity | Medium |
Support Free | YES |