https://www.youtube.com/watch?time_continue=1&v=4qJE2gZh42k
Great little RC boat, which can easily be printed with only 500 g of filament. To make it radio controlled all you need is a SG90 servo motor, 2204 or 2205 brushless motor, brass coupler, 40A esc, rc rudder and a flex shaft.
I glued the boat with the Loctite super attak Power flex gel, but first sand it a little bit on the gluing surface. For better tightness and join I glued it in the inside with the epoxy. After the boat was finished i spray paint it with acrylic colorless paint.
I preffered to print the motor mount with the ABS (due motor heat), and make sure to loctite the bolts on the motor.
The shaft is bought from the BangGood and it is spare part from Volantex V792-2 RC racing boat.it comes with great propeller to be used in this boat!. Make sure to install the propeller around 20 mm from the back wall of the boat as on photos!
I used the normal 2205 brushless quadcopter motor, which doesnt need cooling. Of course cooling can be made like a Cab Cover intake... pm me if you want it.
Boat is controlled by FT009 spare boat rudder and can be found on aliexpress or banggod for around 90 cents.
SG90 is a servo i used. i just glued it with the epoxy and wateproof it in case of water.
Esc can be 40a or more. I use 40A esc from aliexpress from around 3 β¬.
The trims (Fins) you can see on the photo makes this boat just like a little cart so much agile and great in turnings!
The JET version is already in testing!
https://www.youtube.com/watch?time_continue=1&v=4qJE2gZh42k
here is a little clip of driving the boat.. Fins are not installed yet! New video will come soon.
Hi, this is the remake of a boat my teacher (J.H.) from primary school made for school competitions. (original was made from wood). In 2019 it was first time used for primary school competitions. (it works great)
GENERAL!
Size of the boat is 36 cm. To print the boat you will need at least 450 g of red filament and 100 g of black.
For the electric hardware it is recommanded to use 2204/2205 brushless motor, at least 40A airplane esc, one 9g servo motor (SG90/MG90).
Other parts: You will also need a boat shaft (spare part: Volantex V792-2 Shaft), rudder (Feiluf FT009 rudder), fins (FT012 - rudder fins), Coupler (2.3mm to 5mm)
INSTRUCTIONS!
Printing should be done in two pieces for hull, i printed it with the PLA filament with supports. To print the motor mount you will need some ABS filament (so it will be heatproof).
To install the shaft make sure you install it similiar as the photos show, becouse this is probably the most ideal angle and it works great with my boat.
install the motor to the mount and attach it to the front hull.
glue the front and rear hull together. I used Loctite power flex gel. After i glued all parts together i did paint it with no color varnish, so it is even more solid and more glossy.
install the servo (SG90 or MG90), i used hot glue to attach it inside the boat.
glue the rudder to the rear end of the boat (Two component epoxy) - please follow the photos (it works great with the setup in my case)
https://www.youtube.com/watch?v=4qJE2gZh42k&feature=youtu.be