Mechanical universal telephone holder - Mechanical universal telephone holder

This is a universal phone holder that allows you to hold your phone horizontally and vertically. Ideal for supporting your phone at the desk or on your bedside table. What could be better than not holding your phone while you watch a show. It also allows you to charge your phone in both positions. It fits any type of phone, just set it to your own. It supports phones up to 160mm long (horizontal position) and 47mm wide minimum (vertical position). In particular, it allows you to tilt the phone's viewing angle according to your position. The quick lock/unlock mechanism is based on the phenomenon of gravity. When you let go of your phone, the mechanism locks it and when you grasp your phone, the mechanism releases it. All components are printable, you only need a small rubber band. A PDF file in French and in English (Tutorial) will guide you throughout your realization (Printing parameters, Assembly, ...) and I remain available to answer all your comments.

3D file format: STL

Update (15/06/2020): Some have complained of foot weakness. I have just added files with the name V2 which is a reinforced version.

This is a universal phone holder that allows you to hold your phone horizontally and vertically. Ideal for supporting your phone in the office or on your bedside table. What could be better than not holding your phone while you watch a series. It also allows you to charge your phone in both positions. It fits any type of phone, just set it to your own.

It supports phones up to 160mm long (horizontal position) and 47mm wide minimum (vertical position). In particular, it allows you to tilt the phone's viewing angle according to your position. The quick lock/unlock mechanism is based on the phenomenon of gravity. When you let go of your phone, the mechanism locks it and when you grasp your phone, the mechanism releases it. All the components are printable, you only need a small rubber band. A PDF file in English and French (Tutorial) will guide you throughout your realization (Printing parameters, Assembly,...) and I remain available to answer all your comments.

3D file format: STL

Update (15/06/2020): Some people have complained of a weakness in the foot. I just added files with the name V2 which is a reinforced version.

12 Components to be printed

Layer height: 0.2 mm

Nozzle: 0.4 mm

Filament: PLA 1.75mm

Printing temperature: 200°C

Tray temperature: 60°C

All other settings are available in the PDF file.

12 Components to be printed

Layer height: 0.2 mm

Nozzle: 0.4 mm

Filament: PLA 1.75mm

Printing temperature: 200°C

Build plate temperature : 60°C

All other settings are available in the PDF file.