Falcon 9 Big Fairing - with stand (single print rocket)

Updated 7-8-18 Improved realism of landing gears and added more strength to hold side rockets on.

I wanted a single print set of rockets. This is the Falcon 9 big fairing with launch stand. The rocket when sized to 40% can be a single print on CR-10 mini. After about 15 prints later, I came up with this. The stand is capable of holding the Falcon 9, Falcon Heavy, and Falcon 9 big fairing. (plans for other models as well). Without reduction the model is to scale at 1cm to 1 meter.

Since I tend to have hidden compartments, I could not resist. Under the stand is a hidden compartment.

UPDATE 5-27-18: The clamp file and stand that was uploaded was older one. The stand can result in failed print at top when sized at 40%. I've swapped the two files out as of 7:20am pacific time. If you have one prior, I apologize. After reducing the file 40% is when it fails. The newer file corrects this. If you printed the old file at 100% and or sliced it, it will work fine but not for smaller printer. BUT the new file (old one deleted) will fix this issue. As far as the older clamps, has slightly bigger opening. Now the proper one is included. Although the old one will work, just not as well.

See Falcon Heavy at:
https://www.thingiverse.com/thing:2932569

Enjoy

Sherm