JWizard's Hidden Compartment Box (aka Stash Box)

JWizard’s Hidden Compartment Box (aka Stash Box)10/21/2020
Designed by JWizard

Thank you for choosing the JWizard’s Stash Box!

We can all use stash boxes to store our stuff. This box is special in that it has a hidden compartment at the lower rear of the box. The compartment draw does not fall out on its own. It was designed to come out with a small tap on the box. This allows you to conceal your items in an ordinary box. Put items in the top that can be seen. Put items in the bottom rear of the box that should be hidden.

The JWizard Stash Box has been created using JWizard’s custom hinges. Our storage box comes in 2 different pre-made sizes. Create the box that you need in the size and color that you want!

The following Files are included:

JWizard's Hidden Box door tray-large.stl - length 112.5 mm, width 52.5 mm, height 112.5
JWizard's Stash Box-large.stl

JWizard's Hidden Box door tray-small.stl - length 75mm, width 35mm, height 75mm
JWizard's Stash Box-small.stl

Idea’s:

After each box has been printed, carefully open the box. Since there are supports under the hinges, it will take a little more effort to initially open the box. Take your time here so you don’t break the box upon initially opening it. Also there may be excess filament around the hinges that can be removed. Also if there are any hanging strings, they can be removed as well. If the strings are secure you can leave them undisturbed. If the box does not close as expected, clean up the surrounding area.

Conclusion:

JWizard’s Stash Box is the culmination of months of work in creating working hinges that could be applied to this project. We hope you find JWizard’s Stash Box to be both concealing and useful!

Let us know how you like JWizard’s Stash Box. Please post your makes and share your comments! Follow us so that you will be notified when we release our next project.

Thank you for your support,
JWizard

Requirements:

15% infill
Any color PLA
Supports Everywhere

Slicing Instructions:

1. Import the .STL into your slicing program.
   
2. Supports will be created around the top opening and possibly underneath the box cover. The entire interior of the box should not be filled in.
   

Printing Instructions:

Print each of the box and tray draw separately.

Materials used to create model in photos:
Sunlu Green PLA
Hatchbox Blue PLA