DIY Red Bull Holden Steering wheel

Hereby i present my version of the Red Bull Holden steering wheel.

Not a 1:1 otherwise i would pretty hard to build. So did some minor changes, but it still looks like it :)

You will need some 3d printing skills, cause of the buttonbox need some support to get it right.

Why it is like that? The real steering has the buttons slightly recessed in the front plate. This has ensured that you cannot screw the buttons to the front plate, but that you have to place them in the button box underneath. It therefore looks very clean.

Bill of Material:
Electronical:
2x micro lever switch
1x Leo bodnar BU0836A-NC(low profile)
1x Leo bodnar BU0836A break out
4x 15 x 6 N52 Magnet or 8x 15 x 3 N52 Magnet
6x CTS 288 or CTS288v Encoders
10x Leo Bodnar MPS103F/MB2011 or MB2011SS1W01-CA or https://bit.ly/2MVw2fj(fakes)
1x GX12-4pin connector

Front:
3x M5 x 35
2x M3 x 15 (countersunk)
4x M3 x 10

Back:
4x M3 x 10

Encoder:
6x M3 x 6 adjustment screw

Grips:
6x M5 x 20/25
6x M5 lock nut

Shifters:
2x M4 x 30
2x M4 lock nut
4x M3 x 10
4x M3 x 12
8x M3 lock nut
4x M2 x 10/12
4x M2 lock nut

For personal use only - non commercial - not for resale
You cannot sell the digital model, a derivative or adaptation of the model, nor can you sell prints of the model.

If you have any question, if you want to talk about the project, if you want to speak to other builders or if you are interested in new projects, join my Discord: https://discord.gg/mN3FwkN9WB

70% infill with 0.2 layer is enough.