THIS IS A DEMO VERSION, YOU CAN FIND THE FULL VERSION AT

https://www.aguilarworkshop.com/product-page/princess-bubble-gum-s-crown

OR READ MORE ABOUT IT HERE

https://www.aguilarworkshop.com/post/princess-bubblegum-s-crown

Major Features

Crown

The Crown itself is one singular piece with round edges at the bottom as to not agitate your forehead as well aesthetic purposes. No Supports needed and the large base should lend itself to good bed adhesion.

Jewel with Resin Mold

The Jewel comes with a compatible mold shell to allow for easy mold creation and resin casting. As always, remember the below values represent the exact values of the mold/casting but you'll need to mix slightly more to account for resin and rubber left behind on the cup, mixing stick, etc.

Combined Gem Volume: 3.6 mL

Combined Gem Rubber Mold Volume: 10 mL

Sizing Ring

The sizing ring is essentially the bottom of the crown sliced off, it allows you to print a quick base that you can try on to ensure the crown fits, you can scale it as you wish. Note that while you shouldn't encounter any problems with scaling uniformly or non-uniformly, just remember to scale the jewel (and their mold shell if you are resin casting) to the same dimensions.

This means when you load the jewel into your slicer

scale them first

then you can reorient them for printing