Tablet stand

Tablet stand.

This model consists of 5 parts, 2 leadscrews of 4mm, 2 bolts of 3mm, a bolt of 4mm and a nut of 4mm and 2 threaded feets.
The bolt of 4mm has a threaded length of 22mm and the 2 bolts of 3mm a threaded length of 10mm.
The 4mm bolt connects the part where the tablet fits in with the part with an angle of 50°.
This is also a turning point.
The leadscrews have a length of 170mm.
The 3mm bolts at the back can be handled with a screw driver for a thighter fit on the tablet.
Sliding the part upwards can set the tablet in between 90° and max angle 65°.
The feets will be screwed on to the leadscrews of 4mm.
The leadscrews will be screwed on the threaded angle.
This is in a verticale stand of the tablet.
In a horizontal stand the tablet is only using the fit with the angle part.

3d printing the stl files.
The model is not without supports. The fit has supports in the holes and under an overhang where the 3mm bolt is screwed in. With a trimmer and a plier you can break the support away.
The threaded screw holes also contain support, with a screwdriver or trimmer smaller than 4mm you can break it away. After the removed supports you can use the threaded tool to make the thread ready for the leadscrews.
Move this tool in and out the hole to remove the grit until 2 cm then the leadscrew has a thighter fit. Don't do this with the threaded tool in a drill but manualy, with either an unscrewed
drill head or a special holder which comes with these threaded tools.

ABS filament.
Nozzle 225°, heatbed 110°-107°, 40mms, 25%cooling, 10mm outer brim for part fitting the tablet, 5mm outer brim angle part, 5 mm outer brim feets. Cura 4.0 slice