REBIKE Prothèse d'aide au vélo (sans main ou bras) /Bike aid prosthesis (without hand or arm) /

This accessory, allowing to ride a bike without a hand or an arm, has been created to be solid, easy to print and adaptable to most people. It is printed flat and must be thermoformed!

You will need a bar (or a tube) of 20 mm diameter.

Follow the video guide for printing and assembly :

https://youtu.be/kfhm9a0ICQU

Prefer the main version. To do this, you must print the following documents:

• Plug X1

• Tool x1

• Handlebar clamp x1( Thermoformed or screw)

• Non-mobile arm support x1 ( child or adult)

• Mobile support x1

A second version (alternative version) is offered for special cases, it brings an additional adjustment to the arm.

The printing parameters are as follows:

Layer height 0.2

Number of wall lines 5

Number of top layers 10

Number of lower layers 10

Filling 40%.

Concentric top and bottom pattern

No automatic support (manual support on the bike clip)

No raft or skirt

Please reward my work by sending a photo or video of the first use and give me feedback for possible improvements on :

morganjimenez42@gmail.com

Please consider sharing so that all can benefit.

UPDATE 07/2021:

you have the choice of three versions for the arm side :

A stronger adult version A

A lighter child version. B

An alternative version for complex cases C

For the bike side, you can choose between two versions:

A thermoformed version

A screw version with 2 bolts M6 x35 and brake nuts (thanks to Thierry Jaquet for this version)

Google translate:

This accessory, allowing you to cycle without a hand or an arm, was created to be solid, easy to print and adaptable to the greatest number. It prints flat and must be thermoformed!

Follow the video guide for printing and editing:

https://youtu.be/kfhm9a0ICQU

Choose the main version. For this you need to print the following documents:

Plug X1

Tool x1

Handlebar clamp x1( Thermoformed or screw)

Non-mobile arm support x1 ( child or adult)

Mobile support x1

A second version (alternative version) is available for special cases, it provides additional adjustment to the arm.

The print settings are as follows:

Layer height 0.2

Number of wall lines 5

Number of top layers 4

Number of lower layers 4

35% infill

No automatic support (manual support on the bicycle clamp)

No raft or skirt

Please reward my work by sending a photo or video of the first use and give me feedback for possible improvements on:

morganjimenez42@gmail.com

Remember to share so that everyone can benefit.

UPDATE 07/2021:

you have the choice of three versions for the arm side:

A stronger adult version A

A lighter children's version. B

An alternative version for complex cases C

For the bike side, you have the choice between two versions:

A thermoformed version

A screw version provide 2 M6 x35 bolts and lock nuts (thanks to Thierry Jaquet for this version)