Easter Eggs Set (32 models)

Set of 4 Easter Eggs in 8 versions each

• Cage / thick
• Spiral / thick
• Solid
• Solid-spiral
• Carved
• Carved-spiral

Each set is in sepparate zip file (2x less space than stls).

Cage and Spiral are harder to print. May need a lot of supports (especially A and C) - depending on your printer cooling, speed, etc. Keep it in mind when slicing.
Thick version are easier to print.

If you have 2 extruders you may try to print it in two colors by adding Cage to Carved or Spiral to Carved-spiral and setting each models for each extruder. *Carved models should be a little highier above the bed to be centered to Cage or Spiral.

You can do something similar with one extruder.

• Print Carved model with Horizontal expansion set to -0.4-0.7 (Depends on your prints quality, usually -0,5 should be fine, but if your prints are not clean you should go with -0.7)
• Then print Cage / Spiral in two parts (first lower it by ~22-24mm, second print should be rotated by 180dgr and lowered by the hight of the model minus the first number)
• You will need to glue this 3 parts or just merge two halves of the Cage / Spiral

Made in Blender 3D
Printed on Creality Ender 3 with Pearl Gold PLA from Spectrum Filaments

Free 2021 Easter Eggs
https://cults3d.com/en/3d-model/home/easter-eggs-2021

More Easter Eggs in collection
https://cults3d.com/en/design-collections/c47/easter

Edit 31 III 2021
Uploaded updated models (less round edges, should look better) and new Thick versions (easier to print and looks little different)

I printed it with 0.4mm nozzle, 0.12-0.2mm layer hights.

Supports are needed for bottom parts (for Solid and Carved) or whole model (Cage, Spiral)

Original Cage and Spiral can be printed thicker by using positive Horizontal expansion (as named in Cura). It will make parts more sturdy incrising strenght and decreasing print fail possibility.