Pumpkin desk lamp / Lampe de bureau citrouille

Here is a pumpkin model adapted as a desk lamp. Used as a decorative lamp to put a calm atmosphere, it can just be used as a night light. Jack o'lantern.

The pumpkin was modeled on SolidWorks then printed in PLA and the PCB was produced on Proteus then laser engraved.

You will find attached a version of the whole pumpkin, and a version cut in half to be able to add a small circuit board and transform it into a lamp. A DXF file is included with the PCB shape if you want to redo it at home.

Characteristics :

• micro USB power supply

• consumption of 0.1 W

• 46 x 46 x 45 mm (L, W, H)

Materials required:

• PLA

• 1 copper plate 23 x 23 mm

• 1 CMS 1206 box resistance of 150 ohm

• 1 CMS led 1206 box

• 1 micro USB SMD connector

Tools required:

• 3D printer

• laser engraver

Do not hesitate to support me with a simple donation.

================================================

Here's a pumpkin model adapted as a desk lamp. Used as a decorative lamp to set a calm mood, it can just be used as a nightlight.

The pumpkin was modeled on SolidWorks then printed in PLA and the PCB was made on Proteus then laser engraved.

Attached you'll find a version of the whole pumpkin, and a version cut in half so that a small PCB can be added and the pumpkin turned into a lamp. A DXF file is included with the PCB shape if you wish to remake it at home.

Features :

• micro USB power supply

• power consumption 0.1 W

• 46 x 46 x 45 mm (L, W, H)

Hardware required:

• PLA

• 1 copper plate 23 x 23 mm

• 1 x 150 ohm SMD resistor 1206 box

• 1 SMD led 1206

• 1 CMS micro USB connector

Required tools:

• 3D printer

• laser engraver

Don't hesitate to support me with a simple donation.

#UPCYCLINGFIVERR

Artillery SideWinder X1

Layer height: 0.1 mm

Nozzle size: 0.4mm

Infill: 20%

Material: red PLA

Bed temperature: 50 ° C

Nozzle temperature: 200 ° C

Supports are not necessary, or even not recommended

================================================

Artillery SideWinder X1

Layer height: 0.1 mm

Nozzle size: 0.4 mm

Filling: 20%.

Material: red PLA

Plateau temperature: 50°C

Nozzle temperature: 200°C

Supports are not necessary, or even not recommended