Rubber Ducky and Toothbrush for Transformers Kingdom Megatron 3D print model

Alrighty then, this set really came highly requested (for obvious reasons!) so here's another case of you get what you asked for. Presenting the fun bathtime set of the rubby ducky and toothbrush for WFC Kingdom Megatron!

Squish squish the rubber ducky! To provide more display and play options, the rubber ducky comes in two sizes - a normal sized and a smaller one.

Both sizes come with a 5mm port on the underneath which will allow for it to be attached to any standard 5mm port using a short rod segment (we are partial towards using cut to length acrylic rods for this). Also, for each size, there is a version with a 3mm peg in its mouth.

And yes, you guessed right, the 3mm peg in mouth versions is for blast effects! Ducky goes pew pew too!

Just a note - due to the size limits of Megatron's hand, only the smaller version of the ducky will fit here.

Then of course, here's the toothbrush - sized again to fit Megatron's hand. It actually comes with around 170+ individual bristles for better dental hygiene.

And of course, here's an obligatory shot of Megatron having a well-deserved rest in the healing vat (https://www.patreon.com/posts/44256308) from earlier!

===

Hope everyone has as much fun with Megatron's bathtime set as we did putting it together! The duck with all its organic curves started off a little tricky but glad it seemed to work ok in the end.

As always, happy 3d printing! =)

===

This model is not to be uploaded or sold in any form and is intended for personal use only.

Check out more of what we are up to over at our Facebook Page (http://www.facebook.com/FunbieStudios) or website (http://www.FunbieStudios.com/)

Support us on Patreon - https://www.patreon.com/FunbieStudios | Full listing of Models - https://funbiestudios.com/model-catalog