CyberBase System Transfomers Quintesson Pit of Judgement Level 2 3D print model

This set requires both the earlier Pit of Judgement set (https://www.patreon.com/posts/44852478) and the 2x2 floor plates from the free CyberBase Core Set (https://www.patreon.com/posts/33140482).

This set provides the additional level for the Quintesson judges to sit upon, and also brings the upper level to a height of 20cm so that it would be more inline with the standard CyberBase System pieces. With the additional floorspace for the judges, additional figures can be either displayed on the top side of the diorama, or in the underside of the setup.

In order to cover the hollow created by the height difference between the lower and upper tier, two wall pieces are provided which go on the sides of the lower pedestal.

In order to raise the upper tier to 20cm, longer versions of the straight and corner pillars have been provided too.

Together all these should make the setup a little more akin to the what was potrayed on screen back in the day! =)

The attached render shows how the new pieces are positioned and combine with the earlier Pit of Justice set.

===

As always, hope everyone will enjoy 3d printing and putting this enhancement set together!

===

This model is not to be uploaded or sold in any form and is intended for personal use only.

Check out more of what we are up to over at our Facebook Page (http://www.facebook.com/FunbieStudios) or website (http://www.FunbieStudios.com/)

Support us on Patreon - https://www.patreon.com/FunbieStudios | Full listing of Models - https://funbiestudios.com/model-catalog